Journey Dip Switch Settings

Below are the specific dip-switch settings users have contributed for Journey:

            Journey (C) 1983 Bally/Midway
        (C) 1983 Artist & Friends/Nightmare Inc.


OPTION SWITCH SETTINGS

Switch  No 1 (At B3 - Located on SOund I/O P.C. Board)

Function           SW#1 SW#2 SW#3 SW#4 SW#5 SW#6 SW#7 SW8 SW#9 SW#10
----------------------------------------------------------------------
                                   XX   XX   XX   XX   XX  XX    
1 Coin Meter       ON
** @ Coin Meters   OFF

Upright/Mini            ON
Cocktail Table          OFF

**Coin Continue (On)          ON
Coin Continue (Off)           OFF

Freeze Video                                                    ON
**Normal Operation                                              OFF


Switch No 3 (At D14 - Located On Sound I/O P.C. Board)	

Function            SW#1 SW#2 SW#3 SW#4
----------------------------------------------
**Normal Operation  OFF
Sound I/O Diag Mode ON

**Normal Operation       OFF
RAM/ROM Test             ON
Indicates Test Results 
VIA YELLOW LED ON SOUND
I/O Board
FAST FLASH = BAD ROM
SLOW FLASH = BAD RAM


**Normal Operation            OFF
Oscillator Test               ON

**Normal Operation                 OFF
Filter Test                        ON


* No Effect If SW#1 of Switch NO. 3 Is In the OFF Position
** Factory Recommended Settings
XX Not Used

The remainder of the sames common option settings are conducted
during the MACHINE SETUP portion of the self-test mode.		

RACK ADVANCE

1. Turn the power to the game on.
2. Open the coin door

NOTE: Cocktail Table Models Only
Gently pull out the plunger on the Safety Interlock
Switch located just inside the coin door

3. Using the Test Credit Button, put a credit on the game

4. Press the "1 Player" start button

5. IMMEDIATELY set the games Self-Test switch to
   the ON position.

6. By pressing both the "1 Player" and " 2 Player" start buttons
   at the same time (ONLY WHEN THE TRANSPORT SHIP IN THE CENTER
   OF THE 5 PLANETS), the game will advance to the next rack.

7. When finsihed, set the Self-Test switch back to the OFF position